Table of Contents
Advertisement
5) BMC_FRB1 (Force to Stop FRB1 Timer Jumper)
1
6) CLR_CMOS1 (Clearing CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and reset
the CMOS values to factory defaults. To clear the CMOS values, place a jumper cap on the two pins to
temporarily short the two pins or use a metal object like a screwdriver to touch the two pins for a few
seconds.
1
• Always turn off your computer and unplug the power cord from the power outlet before clearing the CMOS
values.
• After clearing the CMOS values and before turning on your computer, be sure to remove the jumper cap from
the jumper. Failure to do so may cause damage to the motherboard.
• After system restart, go to BIOS Setup Exit menu and load factory defaults (select Load Default Values) or
manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
Hardware Installation
BMC_FRB1
1-2 Close: Normal operation. (Default setting)
2-3 Close: Force to Stop FRB1 Timer.
CLR_CMOS1
1-2 Close: Normal operation (Default setting)
1
2-3 Close: Clear CMOS data.
1
- 36 -
Advertisement
Table of Contents
