Table of Contents
Advertisement
Installation
en
Fitting the lower support frame
Fasten the upper and lower part of the support frame at
the specified total height using 10 screws.
Notes
Ensure that the lower support frame is in the correct
■
position. The open side must be facing the hob
control elements.
The support frame can be subsequently re-
■
positioned by loosening the securing screws.
14
Fitting the appliance
Hook the appliance from below into the support
1.
frame.
Ensure that the mains cable is not trapped.
Note:
Fasten the appliance to the support frame using
2.
2 securing screws.
Hook in the retaining clip and screw tight.
3.
Connecting the pipes
If using an aluminium pipe, smooth the
Note:
connection area beforehand.
Exhaust-air pipe Ø 150 mm (recommended size)
Attach the exhaust-air pipe directly to the air-pipe
connector and seal.
Exhaust-air pipe Ø 120 mm
Attach the reducing connector directly to the air-pipe
1.
connector.
Attach the exhaust air pipe to the reducing
2.
connector.
Seal both joints appropriately.
3.
Advertisement
Table of Contents
