Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Making adjustments and selections
It is recommended to perform the focus adjustment after 30 minutes have elapsed with the focus test pattern
displayed.
For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 146).
1)
Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 68)
2)
Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 35)
f Refer to "Navigating through the menu" (x page 77) for the operation of the menu screen.
3)
Press the input selection button (<RGB1> and <RGB2>, or <RGB1/2>, <DIGITAL LINK>, <DVI-D>,
<SDI>, <HDMI>) to select the input.
4)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 46)
5)
Press the <SHIFT> button to adjust the position of the projected image.
6)
If the input signal is the analog RGB signal or the DVI-D/HDMI signal, press the <AUTO SETUP>
button.
7)
Press the <ZOOM> button to adjust the image size to match the screen.
8)
Press the <FOCUS> button again to adjust the focus.
9)
Press the <ZOOM> button again to adjust the zoom to match the projected image size to the screen.
Note
f When the projector is switched on for the first time after purchase, as well as when the [PROJECTOR SETUP] menu → [INITIALIZE] →
[ALL USER DATA] is executed, the focus adjustment screen is displayed after projection starts, and then the [INITIAL SETTING] screen is
displayed. Refer to "When the initial setting screen is displayed" (x page 59) for details.
2)
3)
6)
4)
1) 5) 7) 8) 9)
1) 8)
6)
ENGLISH - 65
5)
7) 9)
2)
3)
Advertisement
Table of Contents
