Page 1
NOTE: This step applies only if more than one GCU is being used. Up to four GCUs can be used. Each GCU will need a different Identity. Set the Identity of the GCU by changing the Dipswitches as shown in the chart below.
Page 2
Operation Open/Close Gate To open a gate enter any valid PIN Number on GAPLM. For multiple GCU’s, enter the PIN Number followed by the GCU Identity (1-4). For a remote control transmitter, press the corresponding button for 3 seconds (within 75' of GAPLM).
There is an error tone when the GCU is activated. The GAPLM or DAILM is not communicating with the GCU. The GCU may be out of range. If the units work properly when close together, the GCU may need to be mounted higher off the ground or on a different surface.