Cannot Print Properly From The Digital Camera - Canon i560 Series Quick Start Manual

Cannot Print Properly from the Digital Camera

The following messages may be displayed on the digital camera or digital video camcorder
when images are printed directly from them. Correct the error according to the procedure
below.
Camera Error Message
Printer in use
Printer warming up
No Paper
Paper Jam
Printer cover open
No print head
Waste tank full
Paper lever error
Printer error
Images can be printed directly from Canon "Bubble Jet Direct" compatible
Note
digital cameras and digital video camcorders connected to this printer.
If the connected digital camera or digital video camcorder does not support
"Bubble Jet Direct", the POWER lamp on the printer flashes eleven times. If
this happens, disconnect the connection cable and press the RESUME/
CANCEL button.
If the operation time or data transmission time is too long when the digital
camera or digital video camcorder is connected to this printer, a
communication time error may occur and no more images can be printed. If
this error occurs, press the RESUME/CANCEL button. They will automatically
turn on. If not, turn it on.
For more details, also refer to the user's manual for the digital camera or
digital video camcorder.
Possible Cause
Images are printed from the
computer.
The printer is warming up.
No paper is loaded.
A paper jam occurrs in the
printer.
The front cover is open.
No print head is installed.
(The POWER lamp on the
printer flashes five times.)
The print head is defective.
(The POWER lamp on the
printer flashes five times.)
The waste ink tank is nearly
full.
Incorrect position of the paper
thickness lever.
An error requiring servicing
has occured. (The POWER
lamp on the printer flashes
alternately orange and green.)
Wait until printing ends. The printer automatically starts
printing the images from the camera after completing the
current printing.
Wait until warm-up ends. When it is ready, the printer starts
printing automatically.
Load the paper in the printer and press the RESUME/CANCEL
button on the printer.
Remove the jammed paper, load new media, and press the
RESUME/CANCEL button.
Close the front cover.
Install a print head according to the
Contact the Customer Care Center.
Press the RESUME/CANCEL button on the printer to recover
from the error. Contact the Customer Care Center as soon as
possible.
Open the front cover and adjust the paper thickness lever to the
left position.
Turn off the printer, unplug the power cord from the power
supply, plug the power cord back in, and then turn on the
printer. If the same error occurs, contact the Customer Care
Center.
Troubleshooting
Try This
Easy Setup Instructions
.
55