Changing The Battery; General Operations; Signal Sources; Teletext Operations - Telefunken TF-LED43S21T2SU Instruction Manual

Operation

Changing the battery

1. Remove the battery compartment cover
on the back of the RC.
2. Insert the batteries into the battery
compartment making sure that the correct
polarity is observed.
3. Install the cover back.
1
• Use two AAA batteries for the RC. The RC
should be pointed at remote sensor within 8
meters and within 30 degrees at the left or the
right side.
• Take the battery out of the RC if it is not
used for a long time.
• Do not mix new and used batteries or
different types of batteries. Weak batteries can
leak and severely damage the RC.
• Do not expose the RC to shock, liquids,
and do not place it in an area with high
humidity.

General operations

Power
• Connect the plug of the power cord to the
mains socket.
• Do not leave your TV in standby mode for
a long period of time; if you are not going to
use the unit, disconnect it from power supply.
• In TV mode the unit will automatically go to
standby mode if no signal for 10 minutes.
Operations
• Press VOL- button repeatedly to decrease
the volume; press VOL+ button repeatedly to
increase the volume.
• Press MUTE to mute sound, press this
button again or increase volume to resume
sound.
• Press
button on the RC to select
from the present channel and the previously
displayed channel.
8
8
2 3
On average, the loading time of the
TV can take up to 40 seconds. However,
the loading time might differ, depending on
the number of installed applications.
• Select the TV function mode. Press
CH-/CH+ buttons to select previous or next
channels; or press number buttons to enter a
channel number directly.
• Press INFO button to display the preset
TV channel play information.
• Press NICAM button in TV mode repeatedly to
switch between various Nicam sound modes
(can be unavailable for some channels. This
function is optional.

Signal sources

Press the INPUT button, then press DOWN/
UP cursor buttons on the RC or on the
keyboard to select a source from available
source list: DVB-T/C => DVB-S => ATV => AV
=> YPbPr => HDMI 1 => HDMI 2 => HDMI3.
Press OK button on the RC to confirm. Cable
TV is selected via the Channel => Antenna
Type menu.
Teletext operations (option)
Select a TV channel in order to pick up the
picture signal of Teletext. Teletext button
functions are as follows:
TEXT: Press this button to enter into TEXT
mode. Press the button again to return to the
channel you are watching.
HOLD: Press this button to stop the move
to the next page. Press this button again to
cancel operation.
INDEX: Press this button to go to the index
page.
REVEAL: Press this button to reveal the
concealed information. Press this button again
to conceal the information.
Red/Green/Yellow/Blue buttons: Press
these 4 color buttons to access directly to
corresponding color page displayed at the
lower parts of teletext screen.