AEG A80230GT User Manual page 31

Problem
There is too much frost
and ice.
The lid doesn't close com-
pletely.
The lid is difficult to
open.
The lamp does not work.
It is too warm in the
freezer.
It is too cold inside the
freezer.
Possible cause
Products are not wrapped prop-
erly.
The lid is not shut properly or do
not close tightly.
The temperature is not set cor-
rectly.
The water drainage plug is not
correctly positioned.
There is excessive frost.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
Food packages are blocking the
lid.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
The valve is blocked.
The lamp is defective.
The temperature is not set cor-
rectly.
The lid does not close tightly or
it is not shut properly.
Before freezing the appliance
was not precooled sufficiently.
Large quantities of food to be
frozen were put in at the same
time.
Food placed in the appliance was
too warm.
Products to be frozen are placed
too closely to each other.
The lid has been opened often.
The lid has been opened for a
long time.
The temperature is not set cor-
rectly.
What to do if...
Solution
Wrap the products better.
Check if the lid closes well and the
gaskets are undamaged and
clean.
Set a warmer temperature.
Position the water drainage plug
in the correct way.
Eliminate excess frost.
Arrange the packages in the right
way, see the sticker in the appli-
ance.
Check the valve.
Refer to "Replacing the lamp".
Set a lower temperature.
Check if the lid closes well and the
gasket is undamaged and clean.
Pre-cool the appliance for
enough time.
Wait some hours and then check
the temperature again. Next time
insert smaller quantities of food
to be frozen at any one time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so
that cold air could circulate
among them.
Try to not open the lid often.
Do not leave the lid open longer
than necessary.
Set a warmer temperature.
31