Sony VPL-VZ1000ESLA Operating Instructions Manual page 7

3
Check if the upper side and lower side of the picture
are parallel.
If not, install the unit in a position parallel to the
projection surface (a=b).
Image distortion Installation state to the projection surface
4
Check if the lower side of the picture is horizontal.
If not, use the left/right feet (adjustable) to keep the
unit level. For details on adjusting the feet, see page 8.
Image distortion
5
Check if the left side and right side of the picture are
vertical.
If not, use the feet (adjustable) to keep the unit vertical
to the projection surface. For details on adjusting the
feet, see page 8.
(Top view)
a b
a > b
a
b
a < b
Feet adjustment
7
Image distortion
Side view
c > 90°
Side view
c < 90°
If the frame of the projection surface is rectangle and
parallel to the floor, adjustment is completed.
Tip
If the picture remains distorted, repeat step 3 and 4.
6
Adjust the feet for preventing backlash to the floor.
Note
The picture may be distorted if you turn the feet for preventing
backlash too much.
7
Press the PATTERN button to display the Lens Shift
adjustment window, and adjust the picture position by
pressing the M/m/</, buttons.
Tip
If you press the RESET button on the remote control while the
Lens Shift adjustment window is displayed, the picture
position returns to the center of the lens (factory default
position).
Feet adjustment
Adjust the foot
near the rear
side so that it is
longer.
Adjust the
height with the
feet near the
front side.