Table of Contents
Advertisement
Name of part
Work attachment
(with a recessed end)
9.5 mm
Feed plate asm., ø13.5 mm
Pan, small
(Feed plate asm., ø22 mm)
Hole diameter ø13.5 mm
Selector plate asm., extra small
(Selector plate, large)
In-line arrangement plate A
Centering ring, large
Part No.
18257204
This work attachment is the same as 18257105 in shape but has a larger bottom
diameter.
When replacing the standard work attachment with this work attachment, re-
adjust the fine positioning completion switch.
18200956
This feed plate has a smaller holes (ø13.5 mm) for carrying buttons when
18201103
compared with the standard feed plate. When a small button (shell buttons, in
(16568651)
particular) of which diameter is ø10 mm is to be fed, the button may be reversed
when it is delivered to the triple pawl or crack when the triple pawl is closed in
accordance with the shape of the button.
To prevent the aforementioned troubles, this feed plate is used in combination
with the pan, small.
If using buttons of which diameter is ø16 mm or more, use the feed plate asm.,
ø22 mm. In this case, the standard pan can be used.
This selector plate is smaller than the selector plate, GBR011220A0. It is suited
18251553
to the flat buttons (shell buttons, in particular) of which diameter is approximately
ø10 mm since, when using such buttons, the selector plate, small, cannot
discriminate the right-sided buttons from the wrong-sided ones with consistency.
When using large buttons, use the selector plate, large.
(GBR01424000)
18213207
This in-line arrangement plate is suited when sewing buttons including marble-
shaped buttons which are likely to be clogged in the standard in-line arrangement
plate.
This plate is designed to prevent buttons from being clogged.
16558207
Use this ring when centering the origin of the button carrier, E, F or H.
−
Application
35
−
Advertisement
Table of Contents
