Mounting Considerations; Minimum Clearances - Genelec 4030BWM Operating Manual

Loudspeaker Mounting Position
Flat anechoic response
Free standing in a damped room
Free standing in a reverberant room
Near field or desktop
Near to a wall
Table 1: Suggested tone control settings for differing acoustical environments
Treble Tilt
The Treble Tilt control (switch 1) attenuates the treble
response of the loudspeaker at frequencies above
5 kHz by 2 dB, which can be used for smoothening
down an excessively bright sounding system.
Bass Tilt
The Bass Tilt control offers three attenuation levels
for the bass response of the loudspeaker below
2 kHz, usually necessary when the loudspeakers
are placed near a wall or other room boundaries.
The attenuation levels are -2 dB (switch 3 "ON"),
-4 dB (switch 4 "ON") and -6 dB (both switches
"ON").
Bass Roll-Off
The Bass Roll-Off (switch 2) activates high-pass
filtering at 85 Hz to match the low frequency cutoff
of the 4030B to subwoofers using 85 Hz low-pass
filtering.
The factory setting for all tone controls is "OFF"
to give a flat anechoic response. Always start ad-
justment by setting all switches to "OFF" position.
Measure or listen systematically through the dif-
ferent combinations of settings to find the best fre-
quency balance.
4
Treble Tilt Bass Tilt
OFF
OFF
OFF -2 dB
OFF -4 dB
OFF -6 dB

Mounting considerations

Align the loudspeakers correctly
Always place the loudspeakers so that their acous-
tic axes (see figure 1) are aimed towards the center
of the listening area. Only vertical placement is pre-
ferred, as it minimises acoustical cancellation prob-
lems around the crossover frequency.
Minimise reflections
Acoustic reflections from objects close to the
loudspeakers like walls, cabinets etc. can cause
unwanted colouration blurring of the sound im-
age. These can be minimised by placing the loud-
speaker clear of reflective surfaces.

Minimum clearances

Sufficient clearance for cooling of the amplifier and
functioning of the reflex port must be ensured if the
loudspeaker is installed in a restricted space such
as a cabinet or integrated into a wall structure. The
surroundings of the loudspeaker must always be
open to the listening room with a minimum clear-
ance of 3 centimeters (1
both sides of the loudspeaker. The space adjacent to
the amplifier must either be ventilated or sufficiently
large to dissipate heat so that the ambient tempera-
ture does not rise above 35 degrees Celsius (95°F)
Bass Roll-Off
OFF OFF
OFF OFF
OFF
OFF
OFF
/ ") behind, above and on
3
16