Table of Contents
Advertisement
Invacare® Action 5/MyOn HC
IMPORTANT!
The parking brakes must be reset after replacing
the rear wheels or changing their position.
Checking after a heavy collision or blow
IMPORTANT!
The wheelchair can sustain visibly undetectable
damage as a result of a heavy collision or hard
blow.
– It is essential to have your wheelchair checked
by a qualified technician after a heavy collision
or hard blow.
Repairing or changing an inner tube
1. Remove the rear wheel and release any air from the
inner tube.
2. Lift one tyre wall away from the rim using a bicycle tyre
lever. Do not use sharp objects such as a screwdriver
which could damage the inner tube.
3. Pull the inner tube out of the tyre.
4. Repair the inner tube using a bicycle repair kit or, if
necessary, replace the tube.
5. Inflate the tube slightly until it becomes round.
6. Insert the valve into the valve hole on the rim and place
the tube inside the tyre (the tube should lie right round
the tyre with no creases).
7. Lift the tyre wall over the edge of the rim. Start close
to the valve and use a bicycle tyre lever. When doing
this, check all the way round to ensure that the inner
tube is not trapped between the tyre and the rim.
8. Inflate the tyre to the maximum operating pressure.
Check that no air is escaping from the tyre.
52
Spare parts
All spare parts may be obtained from an Invacare
authorized provider.
8.3 Cleaning and Disinfection
8.3.1 General Safety Information
CAUTION!
Risk of Contamination
– Take precautions for yourself and use
appropriate protective equipment.
IMPORTANT!
Wrong fluids or methods can harm or damage
the product.
– All cleaning agents and disinfectants used must
be effective, compatible with one another and
must protect the materials they are used to
clean.
– Never use corrosive fluids (alkalines, acid etc.)
or abrasive cleaning agents. We recommend
an ordinary household cleaning agent such as
dishwashing liquid, if not specified otherwise in
the cleaning instructions.
– Never use a solvent (cellulose thinner, acetone
etc.) that changes the structure of the plastic
or dissolves the attached labels.
– Always make sure that the product is
completely dried before taking it into use again.
1587471-F
Advertisement
Table of Contents
