Table of Contents
Advertisement
2.
IDE connectors (40-1 pin PRI_IDE)
The onboard IDE connectors are for Ultra DMA 100/66/33 signal
cables. There are three connectors on each Ultra DMA 100/66/33
signal cable: blue, black, and gray. Connect the blue connector to
the motherboard's IDE connector, then select one of the following
modes to configure your device(s).
IDE Connector
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE
devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
ASUS V-Series M2NC61S
PRI_IDE
R
Drive jumper
setting
Cable-Select or Master
Cable-Select
Master
Slave
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
Mode
Cable
of device(s)
connector
-
Black
Master
Black
Slave
Gray
Master
Black or gray
Slave
4-5
Advertisement
Table of Contents
