Assembly And Adjustments - DeWalt D25960 Instruction Manual

Assembly and adjustments

WARNING: Prior to assembly and adjustment, ALWAYS unplug
tool.
WARNING: Always wear gloves when changing accessories.
The exposed metal parts on the tool and accessory may become
extremely hot during operation.
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT, recommended accessories should be used with
E
this product.
NOTICE: To reduce dust contamination in the tool, keep dust and
debris away from the bit and the beat piece.
Inserting and Removing 1-1/8" (28 mm)
Hex Accessories (fig. 2, 3)
This machine uses chisels with a 1-1/8"
(28 mm) hex shank.
1. Clean the chisel shank (Fig. 2).
TO FIT A CHISEL WITH GROOVE IN THE
SHANK (FIG. 3A)
1. Pull the tool retainer (D) to the unlock
position.
2. Hold the chisel in front of the tool holder with the groove (H) facing
upwards.
3. Insert the chisel shank into the tool holder (E).
4. Push the retainer (D) backwards to lock the accessory in position.
5. Pull on the chisel to check if it is properly locked.The hammering
function requires the chisel to be able to move axially several
centimetres when locked in the tool holder.
6. To remove a chisel pull back the retainer (D) and pull the chisel
out of the tool holder (E).
FIG. 3A
D25960
28 mm
(1-1/8")
TO FIT A CHISEL WITH COLLAR ON THE SHANK (FIG. 3B)
FIG. 2
1. Pull the tool retainer (D) to the unlock position.
2. Insert the chisel shank into the tool holder (E).
3. Push the retainer (D) in line with the accessory shank to lock the
accessory in position.
4. Pull on the chisel to check if it is properly locked.The hammering
function requires the chisel to be able to move axially several
centimetres when locked in the tool holder.
5. To remove a chisel pull back the retainer (D) and pull the chisel
out of the tool holder (E).
22
D
E
H
D