Air Circulation; Installing The Projector In Proper; Position; Moving The Projector - Sanyo PLC-XU4000 Owner's Manual

Safety Instructions

Air Circulation

Openings in the cabinet are provided for ventilation. To
ensure reliable operation of the product and to protect it
from overheating, these openings must not be blocked
or covered.
CAUTION
Hot air is exhausted from the exhaust vent. When using
or installing the projector, the following precautions
should be taken.
– Do not put any flammable object or spray can near the
projector, hot air is exhausted from the air vents.
– Keep the exhaust vent at least 3' (1 m) away from any
objects.
– Do not touch a peripheral part of the exhaust vent,
especially screws and metallic parts. These areas will
become hot while the projector is being used.
– Do not put anything on the cabinet. Objects put on the
cabinet will not only get damaged but also may cause
fire hazard by heat.
Cooling fans are provided to cool down the projector.
The fans' running speed is changed according to the
temperature inside the projector.
Air intake Vent
Exhaust Vent
(Hot air exhaust)
Exhaust Vent
(Hot air exhaust)
6
Air intake Vent
Air Intake Vent

Installing the Projector in Proper

Position

Install the projector properly. Improper Installation
may shorten the lamp life and cause a fire hazard.
Do not roll the projector more than
20°
20 degrees from side to side.
20°
Do not pitch the projector more than
40°
40 degrees from above and below.
40°
Do not point the projector up to project an
image.
Do not point the projector down to project
an image.
Do not put the projector on either side to
project an image.

Moving the Projector

When moving the projector, replace the lens cap and
retract adjustable feet to prevent damage to the lens
and cabinet.
When the projector is not in use for an extended
period, put it into the supplied carrying case with the
lens side up.
CAUTION
The carrying case (supplied) is intended for protection
against dust and scratches on surface of the cabinet,
and it is not designed to protect an appliance from
external forces. Do not transport the projector by
courier or any other transport service with this case,
otherwise the projector can be damaged. When
handling the projector, do not drop, bump, subject it to
strong forces, or put other things on the cabinet.
CAUTION IN CARRYING OR
TRANSPORTING THE PROJECTOR
– Do not drop or bump the projector, otherwise
damages or malfunctions may result.
– When carrying the projector, use a suitable carrying
case.
– Do not transport the projector by courier or any
other transport service in an unsuitable transport
case. This may cause damage to the projector.
For information about transporting the projector by
courier or any other transport service, consult your
dealer.
– Do not put the projector in a case before the projector
is cooled enough.