Kenmore PG-40405S0L Use & Care Manual page 22

Grill Head to Cart
□ This step requires two people to lift and position grill head onto cart.
□ If not already done, remove the tie wrap and packing material from regulator hose, burner
valve and igniter wires located under control panel. Separate the 2 searing burner wires
(straight connection tip) from the other 7 wires (right-angle connection tip) shown in step 6.
Keep the 7 wires shown in step 6 beneath the grill head and inside the panel, and pull the 2
searing burner wires and regulator hose out to the side of the grill head. See A
□ Carefully lower the grill head onto the cart. Make sure the regulator hose and 2 searing
burner wires are hanging outside the cart. Attach head to cart with (4) M6x13 screws. See B
M6X13 screw Qty: 4 pcs
A
22
Pull these 2 searing
burner wires out to
the side of the grill
head
B