Table of Contents
Advertisement
When a mail test is sent, the window below appears when the mail settings have been changed.
In this case, either click the "Send" button to enable the mail setting changes or click the "Cancel" button to
disable the changes, and then send the mail test again.
If the Intelligent Controller unit is processing (check configuration, cut-off, backup, etc.), this screen cannot
be displayed or updated, mail test cannot be sent, and setting change "Send" cannot be performed.
If the Intelligent Controller unit is displaying the initial setting screen (main menu 5) or the Settings screen
(main menu 6), setting change "Send" cannot be performed. In either case, the following window appears.
3-10-1. Server details
When you click the "Server details" button from the [WEB settings] screen, a screen such as shown below appears.
For details on the settings, refer to the operation manual for the Intelligent Controller.
SCREEN DISPLAY AND OPERATION
16
To [3-10-1-1 Receiving
server settings] screen
Advertisement
Table of Contents
