Connecting Wires To Terminals - Kenwood KDC-BT61U Instruction Manual

Connecting Wires to Terminals

To USB device
USB connector (1m)
Microphone input
(KDC-BT61U only)
Microphone
(Accessory 3)
Fuse (10A)
Wiring harness
(Accessory 1)
Light Blue/Yellow (Steering
remote control wire)
Brown (Mute control wire)
If no connections are made, do not
let the wire come out from the tab.
Blue/White (Power control/
Antenna control wire)
Connector A
8 6 4 2
7 5 3 1
Connector B
8 6 4 2
7 5 3 1
Do not remove the
⁄
cap when you do not
use the USB cable. The
connector will cause
the unit to malfunction
if it gets in touch with
any metallic part of the
vehicle.
REMOTE CONT
STEERING WHEEL
REMOTE INPUT
P.CONT
ANT.CONT
Yellow (Battery wire)
Red (Ignition wire)
See next page
⁄
Red (A–7 Pin)
Yellow (A–4 Pin)
R L
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
To Kenwood disc changer/External optional accessory
To connect these leads, refer to the relevant instruction
⁄
manuals.
To use the steering wheel remote control feature, you
need to an exclusive remote adapter (not supplied)
matches your car is required.
To connect the Kenwood navigation system, consult
MUTE
your navigation manual.
Connect to the terminal that is grounded when
⁄
either the telephone rings or during conversation.
(KDC-6051U only)
Connect either to the power control terminal when
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
Rear output
R L
Front output
Sub Woofer output
Antenna Cord
FM/AM antenna input (JASO)
English
63
|