Humidifying Tray / Humidifying Filter Unit - Daikin STREAMER MCK55W Operation Manual

Maintenance
Maintenance
Removing the humidifying tray and
humidifying filter unit
1.
Take out the water tank from the main unit.
2.
Remove the humidifying tray and then remove
the humidifying filter unit from the tray.
Humidifying tray
Lift up slightly and pull out
• Pull out the tray gently, because if there is any water
inside, the water surface may ripple and it may spill out.
• When carrying, hold the base of the humidifying tray.
Attaching the humidifying tray and
humidifying filter unit
1.
Attach the humidifying tray and humidifying
filter unit.
1 Attach the humidifying filter unit to the tray.
Fit axle into groove in humidifying tray
Axle
Groove
2 Fully push in the humidifying tray to the main unit.
• If the humidifying filter unit is not correctly attached to
the humidifying tray, the humidifying tray cannot be
attached to the main unit.
Attention
After installing the humidifying tray to the main unit, do not forcibly
rotate the humidifying filter unit. Malfunction may result.
2.
Put the water tank in.
25
►Page 13
Hold the outer
periphery of
the frame
Humidifying filter unit
Humidifying filter
(orange)
►Page 13
WARNING
Before cleaning and maintenance work, be sure to unplug
the unit. (An electric shock or injury may result)
Humidifying Tray
About every 3 days or when odour or dirt becomes
an issue
Clean with water.
• Use a soft cloth or brush to clean hard-to-reach places.
• For areas on the tray with water scales, clean with a soft
cloth or brush soaked in lukewarm or room temperature
water in which citric acid has been dissolved, and then
rinse with water.
• Be careful not to immerse the silver ion cartridge in
lukewarm or room temperature water in which citric acid
or baking soda has been dissolved. Doing so will result
in loss of the capacity for slime-resistance.
• Citric acid may be purchased at a pharmacy, drug store
or super market.
• Depending on water quality and the usage environment,
water in the humidifying tray may become discoloured
due to water scales etc. In such cases, clean the tray in
accordance with the above.
About float and silver ion cartridge
• Do not remove the float or silver ion cartridge.
• If the float is removed, the Humidifying operation cannot
be run.
If the silver ion cartridge is removed, loss of the capacity
for slime-resistance will result.
Silver ion
cartridge
If the float detaches from the tray
Protrusion Protrusion
on tray on float
Float
2 Insert the axle on the float
protrusion side into the hole of
the tray
3 Insert the axle into the hole of
the tray
Protrusion on tray
• Check the smooth movement of the
Float
float after the attachment.
• If the float rises to the water surface
when the tray is filled with water, it
has been attached correctly.
Sectional view
Wash/Rinse
Float
1 Place the float protrusion
onto the tray protrusion
Humidifying tray