Table of Contents
Advertisement
*4:
To change the settings for "Access Pt.," go to the Web page.
For details, see "Setting the WLAN Network of the projector" (page 39).
If "Access Pt." is set, it is more convenient that you set "Display Setting" in "Network
Presentation" of the projector to "AP Mode" (page 31) in advance when you use Presentation
Function via the network (page 47).
*5:
To change the "Client" settings, use the Web page for change. For details, see "Setting the
WLAN Network of the projector" (page 39).
*6:
If the image output settings of the HDMI device are not appropriate, the bright parts in the
image may become too bright, or the dark ones may become too dark.
*7:
The INPUT E terminal is available on VPL-EW578 only.
*8:
This may not be optimum depending on the input signal. In this case set manually according
to the connected equipment.
*9:
This mode does not work for about three minutes after the lamp lights. A change in signal may
not be detected depending on the input image. The lamp may become brighter at intervals
during lamp dimming. However, this is not a malfunction. If With No Input is set, it takes
priority.
*10: Does not function when "Type A USB", "Type B USB" or "Network" is selected as the input.
In this case, it becomes equivalent to "Standard."
*11: Constant Brightness mode will be enabled for about 2,000 hours after it is activated at early
usage. After this period, it will be disabled automatically. Activated time and brightness may
vary depending on the usage conditions.
*12: Only when "Direct Power On" is set to "Off" and "Standby Mode" is set to "Standard" at the
same time.
*13: Select "Off" to avoid entering standby mode when there is no input signal.
*14: As the lamp is dimmed gradually, you may not notice any change in brightness. You might only
notice that the lamp has dimmed when its brightness is restored after there is a change in input
signal.
*15: This varies depending on the "Lamp Mode" setting.
*16: When "Standby Mode" is set to "Low," the network and network control function cannot be
operated while the projector is in standby mode.
*17: Do not turn off the projector soon after the lamp lights. It may cause a malfunction of the lamp
(does not light ,etc.).
The Connection/Power Menu
33
Advertisement
Table of Contents
