Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZGG65334XA
Summary of Contents for Zanussi ZGG65334XA
- Page 1 User Manual GETTING STARTED? EASY. ZGG65334XA EN User Manual...
-
Page 2: Safety Information
VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. - Page 3 WARNING: Unattended cooking on a hob with fat or oil can be • dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the • appliance and then cover flame e.g. with a lid or a fire blanket. WARNING: The appliance must not be supplied through an •...
-
Page 4: Safety Instructions
SAFETY INSTRUCTIONS plug (if applicable) can make the terminal This appliance is suitable for the following markets: become too hot. • Use the correct electricity mains cable. • Do not let the electricity mains cable tangle. • Make sure that a shock protection is installed. INSTALLATION •... - Page 5 Make sure to connect the appliance according • Do not use large cookware that overlap the to current installation regulations. Pay attention edges of the appliance. This can cause damage to requirements regarding adequate ventilation. to the worktop surface. • Make sure the flame does not go out when you quickly turn the knob from the maximum to the minimum position.
-
Page 6: Before The Installation
• Disconnect the appliance from the mains • Flat the external gas pipes. supply. • Cut off the mains electrical cable close to the appliance and dispose of it. INSTALLATION B. Washer supplied with the appliance WARNING! Refer to Safety chapters. C. -
Page 7: Adjustment Of Minimum Level
applicable pressure adjuster on the gas supply pipe. ADJUSTMENT OF MINIMUM LEVEL To adjust the minimum level of the burners: 1. Light the burner. 2. Turn the knob on the minimum position. 3. Remove the knob and the gasket. WARNING! Make sure to place the gasket exactly in the original position. -
Page 8: Connection Cable
CONNECTION CABLE To replace the connection cable use only the special cable or its equivalent. The cable type is: H03V2V2-F T90. Make sure that the cable section is applicable to the voltage and the working temperature. The yellow / green earth wire must be approximately 2 cm longer than the brown (or black) phase wire. -
Page 9: Possibilities For Insertion
CAUTION! Install the appliance only on a worktop with flat surface. POSSIBILITIES FOR INSERTION The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. Kitchen unit with door 30 mm min 20 mm (max 150 mm) -
Page 10: Product Description
PRODUCT DESCRIPTION COOKING SURFACE LAYOUT Auxiliary burner Rapid burner Multi Crown burner Control knobs CONTROL KNOB Symbol Description Symbol Description minimum gas supply no gas supply / off position ignition position / maximum gas supply DAILY USE WARNING! Refer to Safety chapters. BURNER OVERVIEW A. -
Page 11: Ignition Of The Burner
IGNITION OF THE BURNER If the burner accidentally goes out, Always light the burner before you put turn the control knob to the off position on the cookware. and try to light the burner again after minimum 1 minute. WARNING! Be very careful when you The spark generator can start use open fire in the kitchen automatically when you switch on the... -
Page 12: Care And Cleaning
CAUTION! Make sure that pot Diameter of cook- handles are not above the front edge Burner ware (mm) of the cooktop. CAUTION! Make sure that the pots Multi Crown 180 - 260 are placed centrally on the burner in order to get the maximum stability and Rapid 180 - 240 a lower gas consumption. -
Page 13: Periodic Maintenance
• Remove when the hob is sufficiently cool: components well clean to prevent difficult lighting limescale rings, water rings, fat stains, shiny and check that the burner crown holes are not metallic discoloration. Clean the hob with a obstructed. moist cloth and a non-abrasive detergent. After cleaning, wipe the hob dry with a soft cloth. -
Page 14: Technical Data
LABELS SUPPLIED WITH THE ACCESSORIES BAG Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY A. Stick it on Guarantee Card and send this part C. -
Page 15: Energy Efficiency
3,55 Rapid 0,75 Auxiliary 0,33 ENERGY EFFICIENCY PRODUCT INFORMATION ACCORDING TO EU 66/2014 Model identification ZGG65334XA Type of hob Built-in hob Number of gas burners Left rear - Auxiliary not applicable Energy efficiency per gas burner Left front - Rapid 56.2%... -
Page 16: Energy Saving
EN 30-2-1: Domestic cooking appliances burning gas - Part 2-1 : Rational use of energy - General ENERGY SAVING • Before use, make sure that the burners and pan supports are assembled correctly. • Use cookware with diameters applicable to the size of burners. •... - Page 20 WWW.ZANUSSI.COM/SHOP...