Table of Contents
Advertisement
Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). If necessary, place the handset in the telephone base
or charger to charge the battery. For best performance, keep the handset in
the telephone base or charger when not in use. The battery is fully charged
after 16 hours of continuous charging. See the table on page 42 for battery
operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10
minutes to give the handset enough charge to use the telephone
for a short time. When the battery is low, the handset shows Low battery
has four short beeps to alert you.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators
The screen is blank.
The screen shows
Place in charger and
The screen shows
Low battery and
beeps four times every
minute.
The screen shows
HANDSET X.
If you do not plug in the battery into the handset and place it in the telephone base
or charger, the screen displays No battery.
icon. If you are on a call in low battery mode, the handset
Battery status
Battery has no charge
and the handset cannot
be used.
Battery has very little
charge and the handset
cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
Action
Charge without interruption (at
least 10 minutes).
Charge without interruption (at
least four minutes).
Charge without interruption until
the screen shows HANDSET X
(about 30 minutes).
To keep the battery charged,
place it in the telephone base
or charger when not in use.
4
Advertisement
Table of Contents
