How To Use Remote Controller - Toshiba RAV-RM301KRTP-NZ Owner's Manual

7

HOW TO USE REMOTE CONTROLLER

■
Cooling/heating/fan only operation
Start
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool , Heat
3
Temperature button (
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of
MED , MED
• The OPERATION lamp on the display panel
of the indoor unit goes on. And operation starts
after approximately 3 minutes. (If you select FAN
ONLY mode, the unit will start immediately.)
• The : Fan only mode does not control
temperature.
• Fan speed
HIGH
Therefore, perform only steps
select this mode.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with
a cooling only outdoor model outdoor unit,
appears on the remote controller but the heating
operation is disabled.
1122650203-00_S01_182x257_44p_S_p70_181006.indd 19
1
3
2
4
SWING FAN
)
, or Fan only .
)
LOW , LOW ,
+
, HIGH
+
is the same as
.
1 2 4
, and to
)
■
Dry operation
Start
SWING
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Dry .
3
Temperature button (
Set the desired temperature.
• The fan speed display indicates
• The OPERATION lamp on the display panel
of the indoor unit lights, and operation starts after
approximately 3 minutes.
.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
- 18 -
Owner's Manual
1
3
2
FAN
)
)
.
)
15/11/2561 8:00:37