Table of Contents
Advertisement
Noncombustible Facing
Drywall
2 x 3 Min.
Spacer
Rock Board or
Other
Figure 22
FIREPLACE BLOWER
The fireplace is equipped with a blower. It is
located in the bottom of the fireplace towards
the back. It uses 120V and must be connected to
the main electrical circuit by a qualified electri-
cian prior to enclosing the fireplace.
For connection, use the electrical box supplied
with the unit located on the bottom right side
of the fireplace. To access the electrical box
remove the four screws, pull out the plate and
box and install the electrical receptacle.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
A wall on/off switch must be installed to control
the blower. An optional heat switch and variable
speed control are available (see Page 28).
If installed, the heat activated switch must be
connected to the blower main cable and the
magnets must be stuck under the fireplaces
firebox accessible through the side electrical
box access plate.
If a repair must be done after the fireplace is
installed an access plate is located under the bot-
tom refractory. Remove the bottom refractory,
unscrew the access plate, clean black cement
sealing the access plate and do the repair.
17
Advertisement
Table of Contents
