Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZGGN645K
Summary of Contents for Zanussi ZGGN645K
- Page 1 User Manual GETTING STARTED? EASY. ZGGN645K EN User Manual...
-
Page 2: Safety Information
VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. - Page 3 WARNING: Unattended cooking on a hob with fat or oil can be • dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the • appliance and then cover flame e.g. with a lid or a fire blanket. CAUTION: The appliance must not be supplied through an •...
-
Page 4: Safety Instructions
sleeving) with parts that can reach temperatures of more than 50°C above room temperature. WARNING: Use only hob guards designed by the • manufacturer of the cooking appliance or indicated by the manufacturer of the appliance in the instructions for use as suitable or hob guards incorporated in the appliance. -
Page 5: Gas Connection
• If the mains socket is loose, do not connect the • Do not put cutlery or saucepan lids on the mains plug. cooking zones. They can become hot. • Do not pull the mains cable to disconnect the • Do not operate the appliance with wet hands or appliance. -
Page 6: Installation
opening of a window, or more effective • Do not use water spray and steam to clean the ventilation, for example increasing the level of appliance. mechanical ventilation where present. • Clean the appliance with a moist soft cloth. Use •... -
Page 7: Injectors Replacement
For appliances installed in the Republic of Ireland or they are not squeezed. Also be careful when the please refer to NSAI- Domestic Gas Installation I.S hob is put together with an oven. 813 Current Edition Section 7- Permitted Locations CAUTION! It is important to install the of Appliance. - Page 8 • from natural gas G20 20 mbar to liquid gas, The appliance is supplied with a 3 core flexible fully tighten the bypass screw in. power cable with a 3 amp plug. If it is necessary to • from liquid gas to natural gas G20 20 mbar, change the fuse, use a 3 amp ASTA-approved (BS undo the bypass screw approximately 1/4 1362) fuse.
- Page 9 To replace the connection cable use only H03V2V2-F T90 or equivalent type. Make sure that the cable section is applicable to the voltage load and the working temperature. The yellow/ green earth wire (B) must be approximately 2 cm longer than the live and neutral wire (A).
-
Page 10: Possibilities For Insertion
CAUTION! Install the appliance only on a worktop with flat surface. POSSIBILITIES FOR INSERTION The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. Kitchen unit with door or drawer 30 mm min 20 mm (max 150 mm) -
Page 11: Daily Use
CONTROL KNOB Symbol Description Symbol Description minimum gas supply no gas supply / off position ignition position / maximum gas supply DAILY USE C. Ignition candle WARNING! Refer to Safety chapters. D. Thermocouple IGNITION OF THE BURNER BURNER OVERVIEW Always light the burner before you put on the cookware. -
Page 12: Hints And Tips
CAUTION! In the absence of The hob is supplied with the electricity you can ignite the burner progressive valves. They make the without electrical device; in this case flame regulation more precise. approach the burner with a flame, turn the control knob counter-clockwise to TURNING THE BURNER OFF maximum gas supply position and To put the flame out, turn the knob to the off... -
Page 13: Pan Supports
• Scratches or dark stains on the surface have no effect on how the hob operates. • Use a special cleaner suitable for the surface of the hob. WARNING! Do not use knives, scrapers or similar instruments to clean the surface of the glass or the rims of the burners and the frame (if applicable). -
Page 14: Troubleshooting
• Remove when the hob is sufficiently cool: limescale rings, water rings, fat stains, shiny metallic discoloration. Clean the hob with a moist cloth and a non-abrasive detergent. After cleaning, wipe the hob dry with a soft cloth. • To clean the enamelled parts, caps and crowns, wash them with warm soapy water and dry them carefully before you put them back on. -
Page 15: Technical Data
LABELS SUPPLIED WITH THE The instructions about the Service Centre and ACCESSORIES BAG conditions of guarantee are in the guarantee booklet. Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA... -
Page 16: Other Technical Data
OTHER TECHNICAL DATA Gas original: G20 (2H) 20 mbar 8,9 kW TOTAL POW- Gas replace- G30 (3+) 28-30 mbar 607 g/h ment: G31 (3+) 37 mbar 596 g/h Electric supply: 220-240 V ~ 50-60 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Appliance cate- II2H3+ gory:... -
Page 17: Energy Efficiency
ENERGY EFFICIENCY PRODUCT INFORMATION ACCORDING TO EU 66/2014 Model identification ZGGN645K Type of hob Built-in hob Number of gas burners Left rear - Semi-rapid 54.8% Right rear - Semi-rapid 54.8% Energy efficiency per gas burner (EE gas burner) Right front - Auxiliary... - Page 20 WWW.ZANUSSI.COM/SHOP...