Door Removal And Installation; Fi Bre Fi Rebrick Panels - Napoleon CBI360-2N Installation And Operation Manual

REMOVAL:
A.
Remove the top clips and set aside.
B.
Remove the safety screen from the safety
screen frame by sliding it up and out.
C.
Remove the two screws from the top
brackets of the safety screen frame.
D.
Lift the safety screen frame up and away
from door frame.
INSTALLATION:
E. Install the safety screen frame into the
bottom brackets of the door frame and
secure the top brackets with the 2 screws
into the top brackets of the door frame.
F. Slide the safety screen into the safety screen
frame.
G. Install the top clips.
H. Ensure the safety screen is installed correctly
before using the appliance.
3.2

door removal and installation

To open the door, the safety screen must be
removed to allow the door to be opened or closed.
Remove the upper screws of the door frame
assembly and loosen bottom screws. Lift out the
door frame assembly, handle carefully. Replace the
door glass and gasket.
Reverse these steps to close the door. Ensure the
safety screen is installed correctly before using
appliance.
note:
The protective wrap on plated parts is best re-
moved when the assembly is at room tempera-
ture but this can be improved if the assembly is
warmed, using a hair dryer or similar heat source.
3.3 fi bre fi rebrick panels
To give your insert that authentic masonry look, optional fi bre fi rebrick panels are available at your NAPOLEON /
Wolf Steel Ltd. dealer. Complete installation and maintenance instructions are included with the kit.
A.
B.
C.
D.
fi nishing
SCREWS
W415-2342 / 08.27.19
EN
11