Bosch PROFACTOR GWX18V-13C Operating/Safety Instructions Manual page 18

Lock accessory must not be used until
this condition is eliminated by cleaning
the X-Lock Accessory Mount or replac-
ing the accessory.
Removing accessories
cessory is moving. Ejecting accessory be-
fore the accessory comes to a complete
stop could cause personal injury and/or
property damage.
they have cooled down. The discs can be-
come very hot while working.
bly after release. Falling accessories may
cause personal injury and/or property
damage and can be damaged.
use inspect the accessory such as abra-
sive wheels for chips and cracks, backing
pad for cracks, tear or excess wear, wire
brush for loose or cracked wires. If power
tool or accessory is dropped, inspect for
damage or install an undamaged accesso-
ry. After inspecting and installing an acces-
sory, position yourself and bystanders
away from the plane of the rotating acces-
sory and run the power tool at maximum
no-load speed for one minute. Damaged
accessories will normally break apart dur-
ing this test time.
Before removing the accessory: Make sure
that the power tool has come to a com-
plete stop and is disconnected from pow-
er.
1. Orient the tool to prevent the accesso-
ry from being dropped during release.
2. Open the X-Lock Release Lever (Fig. 10):
(A) Press on the backside of the lever.
(B) Lift the front-side of the lever by
pulling.
3. Remove the accessory from the tool
with care, preventing it from being
dropped.
Never actuate X-Lock
release lever while ac-
Do not touch grinding
and cutting discs until
Do not allow accesso-
ries to fall uncontrolla-
Do not use a damaged
accessory. Before each
Assembly
Clamping
Height Gage
Accessory X-Lock
Mounting Hub
CORRECT: Height of Accessory
X-Lock Mounting Hub is equal or less
than X-Lock Accessory Mount
X-Lock Accessory
Mount
INCORRECT: Height of Accessory
X-Lock Mounting Hub is greater
than X-Lock Accessory Mount
X-Lock Accessory
Mount
Fig. 10
-18-
Clamping Tabs
Accessory X-Lock
Mounting Hub
Accessory X-Lock
Mounting Hub
(A)
(B)
Fig. 9
Clamping
Height Gage