Starting Cold Engine - Echo CS-352 Operator's Manual

OPERATION

Starting Cold Engine

Make sure the bar and chain are free from any obstruction when
starting the chain saw.
1. Move chain brake lever fully
FORWARD to LOCK chain brake
before starting.
2. Fill the fuel tank with fuel mixture.
Do not over fill.
3. Fill the chain oil tank with
lubricant. Do not over fill.
4. Move ignition switch (A) UP to
"RUN" position.
5. Push purge pump (B) 3 to 4
times or until fuel is visible in
purge pump.
6. Pull choke control knob all the
way OUT (CLOSED [
position).
After choke control knob is pulled and then knob is
◆
returned to original position, throttle remains slightly open
(fast idle latch condition).
The chain will attempt to move when engine is started with
◆
fast idle throttle latch engaged.
Do not start engine before chain brake is locked.
◆
30
] choke
CS-352
Chain brake
A
X7503275704
© 09/20 ECHO Incorporated
B