Moving The Outdoor Unit - Samsung RD080HRXGB Installation Manual

preparing the installation

MOVING THE OUTDOOR UNIT

• Select the moving route in advance.
• Be sure that moving route is safe from weight of the outdoor unit.
• Do not slant the product more than 30˚ when carrying it.
(Do not lay the product down sideways.)
• The surface of the heat exchanger is sharp. Be careful not to be get injury while moving and installing.
When moving with a crane or straps
• Fasten the wire rope as seen in the picture.
• T o protect damage or scratches, insert a piece of
cloth between the outdoor unit and the wire rope.
When moving with a fork lift
• Insert the fork into the wooden pallet at the bottom of the
outdoor unit carefully.
• B e careful that the fork does not damage the outdoor unit.
When moving without using wooden pallet with a crane
• Connect the wire rope to the outdoor unit as you move it with a crane.
• Attach the wire rope to the fork lift to move the outdoor unit.
Safety information before the trial operation.
• When the outdoor temperature is low, turn on the main power supply four hours before operating
CAUTION
- If you operate the machine immediately after turning on the main power supply, severe damage
can be caused to parts inside the machine.
• Do not touch the refrigerant pipe during the operation or immediately after the operation.
- While the outdoor unit is operating and immediately after the operation, the pipe is hot or cold
according to the condition of the refrigerant that flows through the refrigerant pipe, compressor,
and refrigerant cycle parts and if you touch the pipe during this time, it can cause burns or
frostbite.
• Do not operate the machine without the product panel and protective net.
- Otherwise, accidents can result from the contact with the components that are hot, spinning or
under the high-voltage.
• Do not turn off the main power supply immediately after stopping the operation.
- Before turning off the main power supply, you should wait at least 5minutes. Otherwise, water
leaks and other problems can be caused.
• E xecute the auto address setting while the power supply to all the indoor units and outdoor units
is connected. Set the auto address after changing indoor unit PCB as well.
10_ preparing the installation
Wire rope/straps
Wooden pallet
Fork lift
Fork lift
Wire rope
Plate protection
cloth
Wooden pallet