Table of Contents
Advertisement
When the memory the full with
30 units of patterns, the
machine will beep to signal it.
Use the arrow "
button to check what you have
programmed.
Press the "
the memory mode and return to
the Direct mode.
The selected pattern will be
cleared from the memory
module after closing the
machine if you do not press the
"
have completed your selection.
Adding patterns or letters
While in the memory mode,
press the "
"
number you have selected is
displayed, then add the new
stitch or change the stitch
length, width, Auto-stop or
mirror, if desire.
The memory has to contain less
than 30 patterns after selected
pattern or letter can be inserted.
Clearing patterns or letters
If you wish to delete a certain
stitch within in the memory
mode, use the "
"
stitch number is displayed.
Press the "
the selected pattern and the
next pattern in the back will
move forward.
64
Note:
" or "
" button to leave
Attention:
" button again when you
" button or the
" button until the stitch
Attention:
" button or
" button until the actual
" button to delete
"
Advertisement
Table of Contents
