Memory Location Scan - Cobra Marine MR HH400 Owner's Manual

Advanced Operation
Operating Your Radio
During Scanning (While Not Receiving
Talk or Channel Up/Down
A Transmission), You Can Choose From
The Following:
a. Press the Talk button to communicate on
the last memory location scanned and return
to Standby mode.
a
b
b. Press the Channel Up or Channel Down
button to change scan direction.

Memory Location Scan

During memory location scan, the radio will rapidly
switch from memory location to memory location.
Whenever any activity is detected, the radio will stop
the scan for ten (10) seconds to allow you to listen
briefly on that memory location. It will then continue
to scan unless you switch out of the Scan mode.
NOTE
The radio must be Squelched for the Memory
Location Scan to function. See page 29 for
Squelch procedure.
NOTE
If there are one or fewer memory locations
programmed in the radio, the Memory Location
Scan option will not be available. See "To Program
Memory Locations" to program at least two (2)
memory locations.
42 English
Advanced Operation
Operating Your Radio
To Enter Memory Location Scan:
Memory Button
1. From Standby mode, press the Memory button.
2. Press the Scan button.
The radio will immediately begin to scan the channels
you programmed into the memory. The Scan and
Scan Button
Memory icons will show on the LCD.
To Exit Memory Location Scan:
1. From Memory Location Scan mode, press the Scan
button. This will return the radio to Standby mode
on the last scanned memory location.
Memory and Scan Icons
During An Incoming Transmission,
You Can Choose From The Following:
a. Press the Talk button to remain on that memory
location and end scanning. This will return the
radio to Standby mode.
b. Press the Channel Up or Channel Down button
to resume scanning memory locations.
Talk or Channel Up/Down
If you do not press any buttons within ten (10)
seconds, your radio will automatically resume
scanning memory locations.
During Scanning (While Not Receiving A Transmission),
You Can Choose From The Following:
a. Press the Talk button to communicate on the last
a
b
memory location scanned and return to Standby mode.
b. Press the Channel Up or Channel Down button to
change scan direction.
Nothing comes close to a Cobra
® 43