Table of Contents
Advertisement
Advanced Operation
Operating Your Radio
Memory Locations
Your radio has ten (10) memory locations for storing your most frequently used
channels. These memory locations can be selected individually or can be scanned
(see Memory Location Scan, page 40).
To Program Memory Locations:
Memory Button
1. Press and hold the Memory button for three (3)
seconds. The memory location number will start
flashing and Memory icon will be turned On.
2. Use the Channel Up or Channel Down button
to change to the memory location (0 to 9) you
Memory Location Number
want to program.
3. Press the Memory button to select the memory
location. The Memory Channel Number will stop
flashing and the channel number will start flashing.
Channel Up/Down
4. Use the Channel Up or Channel Down buttons to
change to the channel you want to store in the selected
memory location.
5. Press the Memory button to program that channel
into the selected memory location. The Memory icon
will begin flashing again.
Repeat steps 2 to 5 to program as many additional
memories as you want, up to a total of ten (10).
Channel Number
6. Press and hold the Memory button for three (3)
seconds. This will return the radio to Standby mode.
To Recall A Stored Memory Location:
1. Press the Memory button. The Memory icon
will be turned On.
2. Press the Channel Up or Channel Down button to
select the memory location (0 to 9). If a memory
Memory Icon
location has been programmed, its associated
channel will be shown on the LCD.
Your radio is now in Standby mode on the selected
memory location.
To Exit Memory Location Mode:
1. Press the Memory button to return the radio to
Standby mode on the last channel shown on the
LCD before entering Memory Location mode.
40 English
Advanced Operation
Operating Your Radio
Channel Scan
Scanning
During scan, the radio will rapidly switch from channel
to channel through all the channels. Whenever any activity
is detected, the radio will stop the scan for ten (10) seconds
88
30
to allow you to listen briefly on that channel. It will then
continue to scan unless you switch out of the Scan mode.
75
60
NOTE
The radio must be Squelched for the Channel Scan
to function. See page 29 for Squelch procedure.
To Enter Channel Scan:
Scan Button
1. From Standby mode, press the Scan button.
The radio will immediately begin to scan the entire
Channel Map selected in the Active Channel Map.
The Scan icon will show on the LCD.
To Exit Channel Scan:
1. From Scan mode, press the Scan button.
This will return the radio to Standby mode
Scan Icon
on the last scanned channel.
During An Incoming Transmission,
You Can Choose From The Following:
a. Press the Talk button to remain on that channel
and end scanning. This will return the radio to
Standby mode.
b. Press the Channel Up or Channel Down button
to resume scanning channels.
Talk or Channel Up/Down
If you do not press any buttons within ten (10) seconds,
your radio will automatically resume scanning channels.
a
b
Nothing comes close to a Cobra
®
41
Advertisement
Table of Contents
