Table of Contents
Advertisement
Available languages
Available languages
en
Switching off and
disconnecting the
appliance
Switching the appliance off
Fig. 2
Press the main On/Off switch 1
(red circle becomes visible).
Temperature display goes out. Fridge
and light are switched off.
Disconnecting the appliance
If you do not use the appliance for a
prolonged period:
1. Switch off the appliance.
2. Pull out mains plug or switch off fuse.
3. Clean the appliance.
4. Leave the appliance door open.
Defrosting
Refrigerator compartment
defrosts fully automatically
While the refrigerating unit is running,
beads of condensation or hoarfrost form
at the back of the refrigerator
compartment. This is quite normal. It is
not necessary to wipe off the
condensation or frost. The rear panel
defrosts automatically. The condensation
runs into the condensation channel,
Fig. +. and is conveyed to the
refrigerating unit where it evaporates.
Note
Keep the condensation channel and
drainage hole clean, so that the
condensation can run out.
26
Cleaning the appliance
ã=
Caution
Do not use abrasive, chloride or acidic
■
cleaning agents or solvents.
Do not use scouring or abrasive
■
sponges. The metallic surfaces could
corrode.
Never clean shelves and containers in
■
the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch the appliance
off.
2. Pull out the mains plug or switch off
the fuse.
3. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
4. Wipe the door seal with clear water
only and then wipe dry thoroughly.
5. Rinsing water must not run through
the drainage hole into the evaporation
area.
6. After cleaning reconnect and switch
the appliance back on.
Advertisement
Table of Contents
