NOTICE :
Make sure the dishwasher is plumb and notice dishwasher can be placed with a small clearance
•
under the counter top.
Turning the screwdriver in the direction of the black arrows will bring the dishwasher back feet
•
up.
Turning the screwdriver in the direction of the white arrows will take the dishwasher rear feet
•
down.
6.4 INSTALLING THE SIDE TRIM STRIPS
Remove the adhesive tape (Figure A).
Place the trim strips on the front edge of the side walls (Figure B).
NOTICE :
Make sure you use the correct trim strip since there is a left and right side strip. The flexible
•
material should be facing forward (Figure B).
6.5 PREPARING THE WATER CONNECTION (A)
Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder
connections must be made before the water line is connected to the dishwasher's water inlet valve.
Water can also be supplied to the dishwasher by using a flexible braided hose line.
Check with your plumbing supply sources for the proper hose and elbow and necessary fittings for
the water supply line. This material is not supplied, and must be purchased separately.
WARNING
Installation should be performed by a qualified installer. Work by unqualified
persons could be dangerous and may void the warranty.
If the dishwasher is installed in a location that experiences freezing temperatures
(e.g. in a vacation home, cabin etc.), you must drain all the water from the
dishwasher's interior. Water system ruptures that occur as a result of freezing are
not covered by warranty.
Water Connection
9
USA