Table of Contents
Advertisement
Installation
8
To adjust the flipper mullion:
1 Loosen the screw located on the
flipper mullion hinge.
Flipper
Mullion
Hinge
Adjusting Flipper Mullion Screw
2 Adjust flipper mullion height. For
proper connection with the flipper
mullion guide, there should be a
separation about the thickness of
a coin (0.060 inches, or 1.5 mm)
between the guide and flipper
mullion.
Flipper
Mullion
Adjusting Flipper Mullion Height
3 Re-tighten screw.
Installing Shelves (select models)
Your refrigerator was shipped with the
shelf hanger and glass shelves in a
shipping pack. Below are the instructions
to install and remove the shelves in your
desired locations.
Flipper
Mullion
1 Place top hooks of the hanger into
2 Relock shelf by pushing the slide
Screw
Mullion
3 While holding shelf at a 45-degree angle
Guide
Thickness
of a Coin
Shelves must be removed prior to
moving the refrigerator.
the desired slot, and lower straight
down until lower hooks rest on the
ladder.
mechanism away from you.
with the gray handle facing you, push
the shelf into the back of the hanger.
CAUTION
Advertisement
Table of Contents
