Table of Contents
Advertisement
CAUTION
Do Not loosen or remove these 3 hex
screws.
Cabinet Leveling & Re-
frigerator Door Alignment
(if necessary)
Guidelines for final positioning of your
refrigerator:
•
All four corners of the cabinet must
rest firmly on the floor.
•
The front should be slightly elevated
to ensure that doors close and seal
properly.
•
Doors should align with each other
and be level.
Most of these conditions can be met by
raising or lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1 Slightly open freezer drawer if the toe
grill is installed. Lift the toe grille and
gently pull forward.
2 Make initial cabinet adjustments by using
the front roller height adjusting screws.
Use a 3/8 inch socket wrench to turn the
adjustment screws (1 per side).
To raise: turn adjustment screw
clockwise.
To lower: turn adjustment screw
counterclockwise.
3 Ensure both doors are bind-free with
their seals touching the cabinet on all
four sides and that cabinet is stable.
4 After unit is leveled, lower anti-tip leg
using a 3/8 inch socket wrench until
it firmly contacts the floor.
DO NOT
Loosen
or
Remove
These 3
Hex
Screws
5 Install the toe grille by fitting into place.
To make final door height adjustments:
1. Open freezer drawer to make lower
hinge visible.
2. Insert 6mm Allen wrench into the
shaft of the lower hinge.
3. Adjust the height by turning clockwise
or counterclockwise. Turning
clockwise will lower the door. Turning
counterclockwise will raise the door.
Default setting is to the lowest height
when you receive your appliance.
Installation
Door
Door
Raise
Anti-tip
Leg
Lower
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
Raise
7
Advertisement
Table of Contents
