Troubleshooting for Anynet +
40
Symptom
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet+.
The message 'Connecting to
Anynet + device...' appears on
the screen.
The Anynet + device does not
play.
The connected device is not
displayed.
The TV programme cannot be
recorded.
The TV sound is not output
through the receiver.
•
Check if the device is an Anynet
•
Connect only one receiver (home theatre).
+ device power cord is properly connected.
•
Check if the Anynet
+ device's Video/Audio/HDMI 1.3 cable connections.
•
Check the Anynet
Anynet+ (HDMI-CEC) is set to On in the Anynet + setup menu.
•
Check whether
•
Check whether the TV remote control is in TV mode.
+ exclusive remote control.
•
Check whether it is Anynet
+ doesn't work in certain situations. (Searching channels, Operating Plug & Play, etc.)
•
Anynet
•
When connecting or removing the HDMI 1.3 cable, please make sure to search devices again or
turn your TV off and on again.
+ Function of Anynet + device is set on.
•
Check if the Anynet
+ device is properly connected to the TV and check if the
•
Check if the Anynet
Anynet + (HDMI-CEC) is set to On in the Anynet + Setup menu.
•
Press the TV button on the TV remote control to switch to TV. Then press the
show the Anynet + menu and select a menu you want.
TV in the Anynet + menu.
•
Select View
SOURCE button on the TV remote control and select a device other than Anynet +
•
Press the
devices.
•
(Note that the channel button operates only when a tuner-embedded Anynet+ device is not
connected.)
•
You cannot use the remote control when you are configuring Anynet
mode.
•
Use the remote control when the Anynet
•
You cannot use the play function when
•
Check whether or not the device supports Anynet
•
Check whether or not the HDMI 1.3 cable is properly connected.
•
Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
Check whether
+ devices again.
•
Search Anynet
•
You can connect an Anynet
support Anynet + functions.
•
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord
or a power failure, please repeat the device scan.
•
Check whether the antenna jack on the recording device is properly connected.
•
Connect the optical cable between TV and the receiver.
Solution
+ device. The Anynet + system supports Anynet + devices only.
+ setting or switching to view mode is complete.
Plug & Play is in progress.
+ functions.
+ device using the HDMI 1.3 cable only. Some HDMI cables may not
TOOLS button to
+ or switching to a view