Kenwood KDC-3047M Service Manual page 11

• Switch in injection setting / packs setting
In the TUNER FM source, every time the [5] key is pressed and held for 1 second the injection setting switches in the following sequence of
order: AUTO → H → L → AUTO.
In the TUNER FM source, every time the [6] key is pressed and held for 1 second the packs setting switches in the following sequence of order:
AUTO → 1 → 2 → . . . 7 → AUTO.
In both settings, the default condition is AUTO, which is displayed as shown in the next table.
Key
Injection setting switching
■5
Packs setting switching
■6
• TUNER setting adjustment mode
This mode is to adjust TUNER setting.
Key
Press this key to change the mode to the TUNER setting adjustment (Press and hold the key for 1 second).
When the source is FM, frequency is switched to 98.3MHz at the start of the adjustment mode.
■DISP
Press and hold the [DISP] key.
Procedures in the TUNER setting adjustment mode are as follows:
• Adjustment mode switching (AUTO/MANUAL)
Key
Level Offset adjustment
■BAND
(Auto)
(forward
rotation)
Level Offset adjustment
(Manual)
• Procedure in the AUTO adjustment mode
Key
In automatic adjustment
Completion of automatic
adjustment
Save the adjustment value.
ROTARY
Failure of the automatic
adjustment
Cannot save the
adjustment value. Save the
failed value (0XFF).
RETURN Mode clear
TEST MODE
Description of display
F M 1 – 4 A
F M 1 – 4 A
F M 1 – 4 A
F M 1 – 4 A
F M 1 – 4 7
Description of display
A S – X X
M S – X X
Description of display
A S – X X
A D J O K
(Level offset value)
A D J N G
F M 1 – 4 A
E R R A
∗ ∗
KDC-3047M/MP1046/MP145/MP145CR/MP146/MP2046
/MP245/MP246AM/MP246G/MP246S/MP3046
A: Injection setting AUTO
9 8 . 1 A
H: Injection setting H
9 8 . 1 H
L: Injection setting L
9 8 . 1 L
A: Packs setting AUTO
9 8 . 1 A
X: Packs setting 1~7
9 8 . 1 A
Note
Press and hold the [BAND] key for 1 second to select the
TUNER adjustment method (A: AUTO / M: MANUAL).
L – X X
S-XX → Present S meter value (HeX)
L-XX → Level offset value (HeX)
∗When the level offset value is not yet adjusted (0XFF or
L – X X
0X00), "--" is displayed.
Press this key briefl y to start the automatic adjustment.
L – X X
After the completion of the automatic adjustment, save the
: X X
level offset value in the Data Flash ROM and display the
resultant level offset value (HeX).
Display shown when the automatic adjustment failed
(Write OXFF in the Data Flash ROM. → Given the OXFF
saved in the ROM, the adjustment starts with "--" when the
automatic adjustment mode is re-started.)
This is to clear the FST adjustment mode (in normal
operation) (The display returns to the normal display and the
9 7 . 9 A
test mode is retained.) Frequency is switched to 97.9MHz.
This is to clear the FST adjustment mode (when failed in the
automatic adjustment) (The display returns to the normal
9 7 . 9 A
display and the test mode is retained.)
Frequency is switched to 97.9MHz.
Description
Description
Description
11