Table of Contents
Advertisement
en Water softening system/special salt
+
Water softening
system / special salt
To ensure good rinsing results, the
l t
s y s t e m / s p e c i a l s a
W a t e r s o f t e n i n g
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l) must
be softened. The water is softened with
special salt (regeneration salt) in the
water softening system
of the dishwasher. The setting and
therefore the required amount of salt
depends on the degree of hardness of
your tap water (see following water
hardness table).
Water hardness table
16
Adjusting the water softening
system
The amount of salt dispensed can be
set from 0 to 62°E. Salt is not required
at the set value 0-8.
Set the softening system as follows:
Ask your local water utility company
1.
for the water hardness value of the
tap water.
Required setting can be found in the
2.
water hardness table.
Open the door.
3.
Switch on ON/OFF switch (.
4.
Press Info button { 8 for 3
5.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button > )* until the
6.
water hardness is indicated on the
display window at the top @.
Make the setting with setting buttons
7.
+ - X.
Press and hold the Info button {
8.
8 for 3 seconds.
The chosen setting has now been
stored.
Using special salt
As soon as the low salt indicator P is
lit on the control panel or is requested
on the front display * ):, salt should
be topped up. Always refill with special
salt immediately before switching on the
appliance. This ensures that overrun
special salt solution is immediately
washed out and does not corrode
the rinsing tank.
Caution!
Detergent will destroy the water
softening system! Never pour detergent
into the salt dispenser.
Advertisement
Table of Contents
