Table of Contents
Advertisement
Tool operators and maintenance personnel must always
comply with the safety precautions given in this manual
and on the stickers and tags attached to the tool and
hose.
These safety precautions are given for your safety. Re-
view them carefully before operating the tool and before
performing general maintenance or repairs.
Supervising personnel should develop additional pre-
cautions relating to the specific work area and local
safety regulations. If so, place the added precautions in
the space provided in this manual.
The CH18 Hydraulic Chipping Hammer will provide safe
and dependable service if operated in accordance with
the instructions given in this manual. Read and under-
stand this manual and any stickers and tags attached
to the tool and hoses before operation. Failure to do so
could result in personal injury or equipment damage.
•
Operator must start in a work area without bystand-
ers. The operator must be familiar with all prohibited
work areas such as excessive slopes and danger-
ous terrain conditions.
•
Establish a training program for all operators to en-
sure safe operation.
•
Do not operate the tool unless thoroughly trained or
under the supervision of an instructor.
•
Always wear safety equipment such as goggles,
ear, head protection, and safety shoes at all times
when operating the tool.
•
Do not inspect or clean the tool while the hydraulic
power source is connected. Accidental engagement
of the tool can cause serious injury.
•
Supply hoses must have a minimum working pres-
sure rating of 2500 psi/172 bar.
•
Be sure all hose connections are tight.
SAFETY PRECAUTIONS
•
The hydraulic circuit control valve must be in the
"OFF" position when coupling or uncoupling the tool.
Wipe all couplers clean before connecting. Use only
lint-free cloths. Failure to do so may result in dam-
age to the quick couplers and cause overheating of
the hydraulic system.
•
Do not operate the tool at oil temperatures above
140 °F/60 °C. Operation at higher oil temperatures
can cause operator discomfort and may damage the
tool.
•
Do not operate a damaged, improperly adjusted, or
incompletely assembled tool.
•
Do not weld, cut with an acetylene torch, or hardface
the tool bit.
•
To avoid personal injury or equipment damage, all
tool repair, maintenance and service must only be
performed by authorized and properly trained per-
sonnel.
•
Do not exceed the rated limits of the tool or use the
tool for applications beyond its design capacity.
•
Always keep critical tool markings, such as labels
and warning stickers legible.
•
Always replace parts with replacement parts recom-
mended by Stanley Hydraulic Tools.
•
Check fastener tightness often and before each use
daily.
•
Never operate the tool if you cannot be sure that
underground utilities are not present.
•
Do not wear loose fitting clothing when operating the
tool.
•
Warning: Use of this tool on certain materials during
demolition could generate dust potentially contain-
ing a variety of hazardous substances such as as-
bestos, silica or lead. Inhalation of dust containing
these or other hazardous substances could result
in serious injury, cancer or death. Protect yourself
and those around you. Research and understand
the materials you are cutting. Follow correct safety
procedures and comply with all applicable national,
state or provisional health and safety regulations
relating to them, including, if appropriate arranging
for the safe disposal of the materials by a qualified
person.
CH18 User Manual ◄ 5
Advertisement
Table of Contents
