Microsd Memory Card; Regulatory Notices; Important Safety Instructions For All Battery Packs - DeWalt DCT416S1 Instruction Manual

NOTICE: Do not point the imaging thermometer (with or without the
lens cover engaged) at the sun or other intensive energy sources that
emit laser radiation. This can damage the detector inside the imaging
thermometer and can effect the accuracy.
MICRO SD MEMORY CARD
WARNING: Choking hazard. The micro SD memory card is a
small part that could lead to a choking hazard and is not intended for
children.
NOTICE: It is recommended to use the micro SD memory card
supplied with the imaging thermometer. D
the use or reliability of other aftermarket cards with different brands
or capacities. It is also recommended to frequently transfer the saved
images to a computer as a backup.

Regulatory Notices

• This Class B digital apparatus complies with Canadian ICES-003.
• This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Important Safety Instructions for All
Battery Packs
WALT does not warrant
E
When ordering replacement battery packs, be sure to include catalog
number and voltage. Consult the chart at the end of this manual for
compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below, then
follow charging procedures outlined.
• Do not charge or use battery in explosive atmospheres,
such as in the presence of flammable liquids, gases or dust.
Inserting or removing the battery from the charger may ignite the
dust or fumes.
• NEVER force battery pack into charger. DO NOT modify
battery pack in any way to fit into a non-compatible charger
as battery pack may rupture causing serious personal injury.
Consult the chart at the end of this manual for compatibility of
batteries and chargers.
• Charge the battery packs only in D
• DO NOT splash or immerse in water or other liquids.
• Do not store or use the tool and battery pack in locations
where the temperature may reach or exceed 105 ˚F (40 ˚C)
(such as outside sheds or metal buildings in summer).
3
READ ALL INSTRUCTIONS
WALT chargers.
E