EnGenius X-TRA ESR600H Manual page 183

Dual concurrent wireless media router
Table of Contents

Advertisement

A
C
PPENDIX
Point-to-Point Protocol over Ethernet (PPPoE)
Point-to-Point Protocol over Ethernet (PPPoE): To set up a PPPoE connection, enter the Username, Password, and Service
(name) of the internet connection provided by your ISP. Click Next and the ESR300H should connect to the internet success-
fully. A PPPoE connection is usually from a DSL internet service.
1. Login: The username or e-mail address that the internet connection uses to access internet connectivity.
2. Password: The password that corresponds to the username or e-mail address used to connect to the internet in the
PPPoE.
3. Service Name: The Service Name is optional. This is to signify the name of the Internet Service Provider.
4. MTU: Maximum Transmission Unit. It specifies the largest packet size permitted for internet transmission. The factory
default MTU size of Static IP is 1500. If you wish to manually change the MTU size, set it between 512 and 1500.
5. Point-to-Point Tunneling Protocol (PPTP)
To set up a PPTP connection, enter the type of WAN connection (Static IP or DHCP). After, depending on the type of WAN,
follow the instructions of DHCP or Static IP to fill out the corresponding information. Then, proceed to enter the Username,
Password, Service, and Connection ID of the PPTP internet connection. Once completed, click Next. Once configured, the
internet connection will successfully connect.
Layer 2 Tunneling Protocol (L2TP)
To set up an L2TP connection, enter the type of WAN connection (Static IP or DHCP). After, depending on the type of WAN,
follow the instructions of DHCP or Static IP to fill out the corresponding information. Then, proceed to enter the Username,
Password, and Service. Click next when completed. Once configured, the internet connection will successfully connect.
MTU: Maximum Transmission Unit. It specifies the largest packet size permitted for internet transmission. The factory default
MTU size of Static IP is 1500. If you wish to manually change the MTU size, set it between 512 and 1500.
ESR600H/ESR750H
C-2
L
L
INK
AYERS
U
G
SER
UIDE

Advertisement

Table of Contents
loading

This manual is also suitable for:

X-tra esr750h

Table of Contents