Cleaning And Storage; Battery And Fuse Replacement - Amprobe AM-250 User Manual

Hide thumbs Also See for AM-250:

Table of Contents

Cleaning and Storage

Periodically wipe the case with a damp cloth and mild detergent; do not use

abrasives or solvents. If the meter is not to be used for periods of longer than

60 days, remove the battery and store it separately.

Battery use:

9V alkaline battery NEDA1604A, JIS6AM6 or IEC6LF22

Fuse:

Fuse (FS1) for µAmA current input:1A/600V, IR 10kA or better, F fuse;

Fuse (FS2) for A current input: 10A/600V, IR 100kA or better, F fuse

Battery replacement for models with battery access door:

Loosen the 2 screws from the battery access door of the case bottom. Lift the

battery access door and thus the battery compartment up. Replace the battery.

Re-fasten the screws.

Fuse replacement:

Loosen the 4 screws from the case bottom. Lift the end of the case bottom

nearest the input jacks until it unsnaps from the case top. Replace the blown

fuse(s) and/or the battery. Replace the case bottom, and ensure that all the

gaskets are properly seated and the two snaps on the case top (near the LCD

side) are engaged. Re-fasten the screws.

Table of Contents

Table of Contents