Table of Contents
Advertisement
Installation
1. In the first time, add the device into the Z-Wave
make sure the primary controller is in the inclusion mode. And then
power on the device, just take out the insulation Mylar in the back side
of the device. The device will auto start the NWI (Network Wide
Inclusion) mode. And it should be included in 5 seconds. You will see
the LED light ON one second.
2. Let the controller associate with the device into the first group, any
light switch that intend to be turned on when the device trig please
associate with the device into the second group.
After finish the test and decide to fix, then you can remove tape A, and
mounting the sensor by using tape B. The tamper key will pressed and
let the sensor enter normal mode.
Z-Wave Configuration Settings
TM
network. First,
Notice:
* All of the configuration, the data size is 1.
* The configuration mark with star(*), means after the exclusion the
setting still keep, don't reset to factory default. Unless the user execute the
"RESET" procedure.
8
Advertisement
Table of Contents
