About Each Function; F1. Fine Tuning Of The Pitch - Yamaha Clavinova CLP-120 Owner's Manual

About Each Function

F1. Fine Tuning of the Pitch

You can fine tune the pitch of the entire instru-
ment. This function is useful when you play
the Clavinova along with other instruments or
CD music.
1. Engage Function mode and select
2. Use the [–/NO] and [+/YES] buttons to lower
or raise the pitch of the A3 key in approxi-
mately 0.2 Hz increments.
.....
Tenths of a hertz are indicated on the LED display by
the appearance and position of one or two dots, as in
the following example:
Display
Hz (Hertz):
This unit of measurement refers to the frequency of a sound
and represents the number of times a sound wave vibrates in
a second.
You can also use the keyboard to set the pitch (in any
mode other than Function mode).
To tune up (in about 0.2Hz steps): Hold the A-1 and B-1
keys (two white keys at the left end) simultaneously and
press any key between C3 and B3.
To tune down (in about 0.2Hz steps): Hold the A-1 and A -
1 keys (a white and a black key at the left end) simulta-
neously and press any key between C3 and B3.
To restore standard pitch: Hold the A-1, A -1 and B-1 (two
white keys and one black key at the left end) simultaneously
and press any key between C3 and B3.
• Refer to "Part Names" on page 14 for information on
the key and key name assignment.
(During the procedure described above, the display indi-
cates a value in Hz <
dure, the display returns to the previous indication.)
40 Detailed Settings – [FUNCTION]
CLP-130/120
.....
Value
440.0
Setting range:
427.0–453.0 (Hz)
440.2
440.4
Normal setting:
440.0 (Hz)
440.6
440.8
TERMINOLOGY
TIP
... >. After the proce-
You can also tune in about 1Hz steps (in any mode other
than Function mode).
To tune down or up, respectively, in approximately 1 Hz
increments: Hold the A-1 and A -1 keys (a white and a black
key at the left end) or A-1 and B-1 keys (two white keys at the
left end) simultaneously and press the [–/NO] or [+/YES] but-
ton.
To restore standard pitch: Hold the A-1 and A -1 keys (a
.
white and a black key at the left end) or A-1 and B-1 keys
(two white keys at the left end) simultaneously and press the
[–/NO] [+/YES] buttons simultaneously.
(During the procedure described above, the display indi-
cates a value in Hz <
dure, the display returns to the previous indication.)
TIP
... >. After the proce-