Schwinn 700IC Assembly Manual / Owner's Manual page 28

Condition/Problem
Resistance is uneven
when pedaling
Unit rocks/does not sit
level
Pedals loose/unit difficult
to pedal
Clicking sound when
pedaling
Seat post movement
28
Things to Check
Check Speed Sensor
Assembly
Brake assembly
Check level adjustment
Check surface under unit
Check pedal to crank
connection
Check crank arm to axle
connection
Check drive belt tension
Check pedal to crank
connection
Check locking pin
Check locking knob
Speed Sensor Assembly should be aligned with magnet and
connected to data cable. Realign sensor if necessary. Replace
if there is any damage to the sensor or the connecting wire.
Contact your local distributor for further assistance.
Lubricate the brake pad with silicone lubricant. Refer to the
brake lubrication procedure in the service manual.
Levelers may be turned to level machine.
Adjustment may not be able to compensate for extremely un-
even surfaces. Move machine to level area.
Pedal should be tightened securely to crank arm. Be sure con-
nection is not cross-threaded.
Crank arm should be tightened securely to axle.
Refer to the "Adjust the Belt Tension" procedure in the Service
Manual.
Remove pedals. Make sure there is no debris on threads, and
reinstall the pedals.
Be sure adjustment pin is locked into one of the seat post
adjustment holes.
Be sure knob is securely tightened.
Solution