How To Remove Panels - Hoshizaki KML-500MAJ Instruction Manual

• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a dispenser unit or ice storage bin. The ice storage
bins listed below are recommended.
Model Number Bin Width
KML-325M_J
KML-500M_J
KML-700M_J
For further options, contact your local Hoshizaki distributor.
• NOTICE! Remote model must be connected to an appropriate remote condenser
unit. The remote condenser unit listed below is recommended. Connection to a
different remote condenser unit will void the warranty unless Hoshizaki approves
a different remote condenser unit for your specific application. For further
details, contact your local Hoshizaki distributor.
Model Number Recommended Hoshizaki Remote Condenser Unit
KML-700MRJ URC-9F
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and towards you.
• Top Panel: Lift up at front slightly, push rearward, and lift off.
• Right Side Panel: Remove the screw. Slide forward slightly and lift off.
• Front Insulation Panel: Lift up slightly, and pull towards you.
• Top Insulation Panel: Lift off.
Top Insulation Panel
Front Insulation Panel
Screw
Recommended Hoshizaki Ice Storage Bin
30" or Wider B-500 Series
Top Panel
Front
Panel
Fig. 1
Screw
13
Right Side Panel