Pc Input Terminals Connection - Panasonic TH-50PX500U Operating Instructions Manual

Connection

PC Input Terminals Connection

COMPUTER
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)
(2) The maximum resolution:
Model
TH-42PX500U
TH-50PX500U
If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
(3) Some PC models cannot be connected to the set.
(4) There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal.
(5) The computer shown in the illustration is for example purposes only.
(6) Additional equipment and cables shown are not supplied with this set.
Signal Names for D-sub 15P Connector
11 12 13 14
6 7 8 9 10
1 2 3 4
Pin Layout for PC Input
Terminal
14
Conversion adapter (if necessary)
4:3
768 × 768
1,024 × 768
Signal Name
Pin No.
15
1
2
5
3
NC (not connected)
4
GND (Ground)
5
AV IN
R AUDIO IN L
RGB
PC cable
Less than
Ferrite core
10cm (4")
(Small size white color)
Connect a cable which matches the audio output terminal on the
computer.
Aspect
16:9
1,024 × 768
1,366 × 768
Pin No. Signal Name
R 6 GND (Ground)
G 7 GND (Ground)
B 8 GND (Ground)
9 NC (not connected)
10 GND (Ground)
Less than
10cm (4")
D-sub 15p
Ferrite core
(Small size gray color)
Stereo plug
Pin No. Signal Name
11 NC (not connected)
12
13 HD/SYNC
14
15
Audio
NC
VD
NC