Pc Input Terminals Connection - Panasonic TH-37PW7BX Operating Instructions Manual

PC Input Terminals connection

Installing the ferrite core (Small size)
1
Installing the ferrite core (Large size)
1
Notes:
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 640 × 480 dots (TH-37PW7BX, TH-42PW7BX), 1,024 × 768 dots (TH-
50PHW7BX) when the aspect mode is set to "4:3", and 852 × 480 dots (TH-37PW7BX, TH-42PW7BX), 1,366 × 768
dots (TH-50PHW7BX) when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it
may not be possible to show fine detail with sufficient clarity.
• The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you
will need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
• To use sync input VBS signals, use the connector which incorporates a 75-ohm termination resistance and which is
available on the market, for the connection of the HD connector where the VBS signals are to be input.
Signal Names for D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin Layout for PC Input
Terminal
COMPUTER
Conversion adapter
(if necessary)
Connect a cable which matches
the audio output terminal on the computer.
2
Pull back the tabs
(in two places)
2
Pull back the tabs
(in two places)
Pin No. Signal Name
1
2
3
4 GND (Ground)
5 GND (Ground)
VOL
INPUT MENU - + ENTER
R - STANDBY
G POWER ON
Less than
Ferrite core (Large size)
10 cm
(supplied)
Ferrite core (Small size)
(supplied)
Audio
3
Open
3
Open
Pin No. Signal Name
R 6 GND (Ground)
G 7 GND (Ground)
B 8 GND (Ground)
9 NC (not connected)
10 GND (Ground)
Connections
PC IN
D-sub 15p
RGB
PC cable
Less than
10 cm
Stereo plug
Press the cable
through and close
Press the cable
through and close
Pin No.
11 GND (Ground)
12
13
14
15
AUDIO
Signal Name
SDA
HD/SYNC
VD
SCL
9