Table of Contents
Advertisement
End of the Pyrolytic cleaning cycle
At the end of the pyrolytic cycle, a buzzer
sounds briefly, which can be deactivated
by touching any point of the display.
The door remains locked until the
temperature inside the oven returns to a
safe level.
A message will appear on the display to
indicate that the oven cavity cooling
procedure is in progress.
• Wait for the oven to cool down and
collect the residue deposited inside it
using a damp microfibre cloth.
During the first pyrolytic cycle,
unpleasant odours may occur due
to the normal evaporation of oily
manufacturing substances. This is
an absolutely normal phenomenon
which disappears after the first
pyrolytic cycle.
If the pyrolytic cycle gives
unsatisfactory results at minimum
duration, it is recommended to set
a longer time for successive
cleaning cycles.
70
Cleaning and maintenance
During the pyrolytic cycle the fans
produce a more intense level of
noise due to a greater rotation
speed. This is an absolutely normal
operation, intended to provide
more effective heat dispersal. At
the end of the pyrolytic cycle, the
fans will continue to operate for
long enough to avoid overheating
the walls of adjacent units and the
front of the oven.
4.4 Extraordinary maintenance
Removing and installing the door seal
(not on pyrolytic models)
To remove the seal:
• Release the clips located in the 4 corners
and pull the seal outwards.
To refit the seal:
• Hook the clips in the 4 corners onto the
seal.
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-
abrasive sponge and wash with
lukewarm water.
Advertisement
Table of Contents
