Page 1
Inspire Electric Fireplace Model: ICVCEFP01 Trim Models: ICVCTK01 Black, ICVCTK02 Pewter, ICVCTK06 Ebony Black w/Brushed Nickel Accent, ICVCTK07 Burnished Black ALWAYS READ THIS MANUAL FIRST BEFORE ATTEMPTING TO INSTALL OR USE THIS FIREPLACE ALWAYS COMPLY WITH ALL WARNINGS AND SAFETY...
Replacement Parts ... 10 Warranty ... 11 Thank you and congratulations on your purchase of a CFM Corporation electric fireplace. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to fol- low these instructions may result in a possible electric shock, fire hazard and will void the war- ranty.
Installation Instructions General 1. Read all instructions before using this appliance. 2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this appliance. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains away at least 3’...
Inspire Electric Fireplace Fireplace Dimensions 35�����” (910 mm) [Heater Main Body Width 32���” (832 mm)] Electrical Specifications Voltage 120V ac, 60 Hz Total Amps 7.9 Amps Total Watts 1050W Heater Rating 2 x 500W Illumination 2 x 20W Low Energy Bulb Electrical Connection A 15 amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required.
Direct (Hard) Wiring Electric Fireplace WARNING • This procedure must be conducted by a qualified elec- trician, in accordance with National and local codes. In the U.S.A., the installation must conform to the National Electrical Code, ANSI/NFPA No. 70. In Canada, the installation must conform to the current CSA C22.1 Canadian Electrical Code.
Inspire Electric Fireplace Fireplace Assembly Unpack the Appliance The Inspire Electric Heater is supplied in two (2) car- tons. All instructions should be read before beginning installation. Carton 1 contents 1, Electric heater main body 1, Remote control handset with battery 1, Mounting hanger 1, Mounting hardware kit [#12 x 1/2”...
Page 7
Insert Panel Fig. 3 Place insert panels on either side of trim. 5. Hang the trim to the heater main body’s upper trim ������ support at a slight angle and between the trim insert panels. Slowly, swing the trim down until the mag- ����...
Inspire Electric Fireplace Operating Instructions Heater Operation The heater is operated by the remote control handset. A master ON/OFF switch is located under the appliance on the left hand side. This is used to turn the appliance completely off. All further operations are controlled by using the remote control handset.
Always use the recommended 20 watt compact fluorescent light bulbs. Never install incandescent light bulbs in this fireplace. It is advisable to use genuine CFM Corporation replace- ment parts available from your authorized dealer. Light Bulb Replacement 1. Disconnect the appliance from the main power sup- ply.
Inspire Electric Fireplace CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. Inspire Replacement Parts Ref. Description 1. 20W Energy Saving Bulb* 2. Pebble Pack (not shown) 3.
Vermont Castings product. 9. The warranties as outlined within this document do not ap- ply to non-CFM Corporation accessories used in conjunc- tion with the installation of this product. This warranty is void if: a) The fireplace has been operated in atmospheres...